#!/bin/sh set -e case "$1" in configure) if ! getent passwd miredo >/dev/null; then adduser --quiet --system --home /var/run/miredo --no-create-home miredo fi if [ ! -e /dev/net/tun ]; then echo "Creating required /dev/net/tun device file..." (cd /dev; ./MAKEDEV tun) || true fi ;; esac # Automatically added by dh_installinit/13.11.4 if [ "$1" = "configure" ] || [ "$1" = "abort-upgrade" ] || [ "$1" = "abort-deconfigure" ] || [ "$1" = "abort-remove" ] ; then if [ -z "${DPKG_ROOT:-}" ] && [ -x "/etc/init.d/miredo" ]; then update-rc.d miredo defaults >/dev/null if [ -n "$2" ]; then _dh_action=restart else _dh_action=start fi invoke-rc.d --skip-systemd-native miredo $_dh_action || exit 1 fi fi # End automatically added section # Automatically added by dh_installsystemd/13.11.4 if [ "$1" = "configure" ] || [ "$1" = "abort-upgrade" ] || [ "$1" = "abort-deconfigure" ] || [ "$1" = "abort-remove" ] ; then # The following line should be removed in trixie or trixie+1 deb-systemd-helper unmask 'miredo.service' >/dev/null || true # was-enabled defaults to true, so new installations run enable. if deb-systemd-helper --quiet was-enabled 'miredo.service'; then # Enables the unit on first installation, creates new # symlinks on upgrades if the unit file has changed. deb-systemd-helper enable 'miredo.service' >/dev/null || true else # Update the statefile to add new symlinks (if any), which need to be # cleaned up on purge. Also remove old symlinks. deb-systemd-helper update-state 'miredo.service' >/dev/null || true fi fi # End automatically added section # Automatically added by dh_installsystemd/13.11.4 if [ "$1" = "configure" ] || [ "$1" = "abort-upgrade" ] || [ "$1" = "abort-deconfigure" ] || [ "$1" = "abort-remove" ] ; then if [ -d /run/systemd/system ]; then systemctl --system daemon-reload >/dev/null || true if [ -n "$2" ]; then _dh_action=restart else _dh_action=start fi deb-systemd-invoke $_dh_action 'miredo.service' >/dev/null || true fi fi # End automatically added section